Official FAQ, Video, customer Software download link will be based on user feedback and will continuously provide to an upgrade.
Laser facility x 1
Focusing Glasses x 1
Data/Power Cable(Mini usb to usb) x 1
Power Cable (usb to usb) x 1
L-TYPE WRENCH x 1 MicroSD card(driver / software etc.) x 1
Manual x 1
Before you can use a computer and laser facility for engraving, you need to install a facility driver which allows the facility to communicate with the computer, furthermore you need to install an application software on your computer so that you can start your engraving. The same situation applies to the Laser Engraver, you need to install the USB-Serial driver which allows the Laser Engraver to talk to the computer, and you need to install the engraver software in order to control the Laser Engraver. NEJE DK-8-KZ,DK-8 PRO-5,DK-6 PRO-5,JZ-5,JZ-5-T,DK-5 Pro-5 engraver comes with a 1GB micro SD card, the files on the SD card are including the USB-Serial driver, engraver software and few JPG photos as shown in figure below. The software is compatible to Win XP, Win 7, Win 8 ,Win 10,system.
As mentioned above, the MicroSD card contains the USB-Serial driver that you can install it on your computer.
Connecting the data and power cables to your computer or other power
The 5V 1A power adapter is connected to the laser engraver via a USB A-A cable, and the data port on laser engraver is connected to the computer’s USB port via a Mini USB cable.
Open the software (Laser_Carver)
When the software is activated, it will activate the facility self-action,
Prepare images for engraving
The MicroSD card contains sample images with resolution 512×512 pixels.
Adjusting focal length
Before engraving, make sure the focus of the laser lens is adjusted and corresponding to the thickness of the material.
1. Wear the safety glasses
2. Adjust focal length until the beam of light is the minimal point
|Temperature：||400 degree celsius|
|Image Size: :||512×512 pixels|
|Engrave Mode：||Bitmap carving|
|Input：||Dual USB(5V 1A)|
|Carving area:||38 x 38mm|
|Laser can replace:||YES|
|Every work time:||< 1 hour|
|Laser Warranty time:||3 month (Laser and control board)|